How To Attach Shed Roof Trusses To Top Plate

Toenail the trusses to the top plate using 16d spiral or ring nails.

How to attach shed roof trusses to top plate.

Notching posts needs to be done by a seasoned professional however. As the workers position each subsequent truss they attach it to the wall plates and to the ridge beam. However there is another way of constructing the truss. Then the end of the bottom chord was cut to allow the top chord to overhang.

The beam extends to the far end of the roof hanging over the trusses still sitting there. Another great way of attaching the truss end to the top wall plate is to use a simpson fastener shown in the picture above which you can find at your local lumber store. See photo at right the truss rafter is then fastened to the post with nails or bolts. Stand the first truss on the end of the wall flush with the outside end of the wall.

A classic choice for securing your rafters is toenailing involves connecting the rafter to the top plate using nails driven into the beam and the wall cap. Lay the trusses on top of each other to make sure they are all the same. Different methods to attach rafters to the top plate 1. This is a special circumstance because some shed plans will have the top chord attach to the roof with a birdsmouth cut out.

Since rafters are the most common choice for small home sheds we ll be focusing on different ways to attach beams to your shed s top plate. Some building codes around the country require the use of a hurricane tie also shown above to add extra reinforcement for holding down roof trusses in the event of very strong winds. How to connect trusses to the top plate. Or fasten the trusses to wall plates using hurricane brackets with 10d nails or simpson strong tie fasteners.

Another method employed by some contractors is to notch the structural post at the top and place the trusses or rafters on top of the notch. Lift the trusses onto the top plates space them as planned and secure them to the wall plates. Toenail a truss into the top of the wall plate by nailing through the sides of the bottom chord at a 30 degree angle. Measure and mark the top plate of the walls on either side of your structure running in line with the proposed roof s ridge every 24 inches.